Sizing guide bracelets

▶ IMPRESSION OPTION

To get the best results, you will need to go to the ‘printing option’ before printing and ensure that the ‘page scaling’ option is set to ‘none’ in the print dialogue box. The Cartier Wrist Sizer must be printed on a full letter size (8 ½ x 11 inches) size page. To check that the Wrist Sizer has been printed properly, take a ruler and measure the sample below. It should measure exactly 2 cm.



rule example


▶ HOW TO USE THE CARTIER WRIST SIZER

  • Cut out the paper Wrist Sizer and follow the instructions below.
  • Make sure that the numbers are on the outside of the paper Wrist Sizer and insert the pointed end through the opening you have cut at the the other end of the Wrist Sizer where indicated [cut here]. Place your hand through the Wrist Sizer and pull the pointed end until it fits comfortably on your wrist.
  • The number that lines up with the edges of the opening is the size of the wrist.
  • You can also use a tape measure but if you do not have one, take any small piece of ribbon or cord. Wrap it around your wrist and measure the length against a ruler.


bracelet illustration

CHOOSING
THE SIZE OF
A LOVE BRACELET:

The usual bracelet sizing rules differ slightly in this case due to the design of the LOVE bracelet. Once you have found your size in the Bracelet Sizing Chart, Cartier recommends adding one centimeter for a tight fit and two centimeters for a loose fit.


Please note that the Cartier Wrist Sizer is an indicative guide only and thefore may not be an exact measure.